Thermo Scientific thermoscientific Vanquish Pumps C, Руководство по эксплуатации

Страница: 240 / 296

10 • Modifying the Pump for Specific Applications
Page 240 Pumps C, Pumps F ( VC-Pxx, VF-Pxx)
Operating Manual
4. Pull the static mixer out of the mounting bracket.
5. Remove the assembly of static mixer and capillary mixer from the
pump.
6. Disconnect the capillary mixer from the static mixer.
10.1.2.2 Installing a Mixing System with a Volume higher than 100 µL
Parts required
Static mixer as required for the mixing system (see Available Mixing
Systems ( } page 237) ).
Tools and additional items required
• Depending on the fitting connection on the capillaries
¨
Viper capillary: Viper knurl (usually present on the capillary)
¨
Conventional capillary (non-Viper): Open-end wrench, size 1/4"
• Solvent suitable for purging
• Screwdriver, Torx T10 (required only for static mixers with a volume
of 750 µL or 1500 µL)
Preparations
1. If not yet done: Remove the mixing system with which the pump is
shipped (see Removing the Mixing System (
}
page 239) ).
2. Only required if you want to install a static mixer with a volume of
750 µL or 1500 µL
These mixers require a different mounting bracket. Install the new
mounting bracket. The mounting bracket is included in the mixer
shipment.
Installing the New Mounting Bracket
Required only for static mixers with a volume of 750 µL or 1500 µL
1. Remove the mounting bracket that is installed in the pump. Mind
the orientation of the bracket. The orientation is important for the
new bracket.
Binary pump : Keep the spacer sleeves. You will need them when
installing the new mounting bracket.