Thermo Scientific 5028i, Инструкция по эксплуатации

Страница: 283 / 330

C-Link Protocol Commands
Measurement Configuration
Thermo Fisher Scientific Model 5028
i
Instruction Manual B-43
pres comp
This command reports whether pressure compensation is for actual
or standard conditions. The following example shows the pressure
compensation is standard.
Send: pres comp
Receive: pres comp std
set pres comp selection
selection = | act | std |
These commands turn the pressure compensation to either actual
or standard conditions. The following example turns the pressure
compensation to actual.
Send: set pres comp act
Receive: set pres comp act ok
pres std a/b
This command reports the standard pressure. The following example
reports that the standard pressure is 760 mmHg.
Send: pres std a
Receive: pres std a 760 mmHg
Send: pres std b
Receive: pres std b 760 mmHg
set pres std a/b
value
This command sets the standard pressure to value , where value is a
floating-point number representation of standard pressure between 0 to
760 mmHg. The following example sets the standard pressure to 730
mmHg.
Send: set pres std a 730
Receive: set pres std a 730 ok
Send: set pres std b 730
Receive: set pres std b 730 ok
range a/b
This command reports the current PM range. If the mode is incorrect,
the instrument responds with “can’t, wrong settings”. The following
example reports that the PM range is set to 5 mg/m
3
, according to Table
B–5 .
Send: range a
Receive: range a 4: (5.000E+00 mg/m3)
Send: range b
Receive: range b 4: (5.000E+00 mg/m3)