Thermo Scientific 5028i, Инструкция по эксплуатации

Страница: 104 / 330

Operation
Instrument Controls Menu
3-50 Model 5028
i
Instruction Manual Thermo Fisher Scientific
The User Value screen allows the user to set the output value for
the corresponding input voltage for the selected table point in the
conversion table, from -9999999 to 99999999. The default table is a
two-point table with point 1: 0.00 V = 000.0 U and point 2: 10.00 V =
10.0 U, where U is the previously entered unit of measure.
l
In the Main Menu, choose Instrument Controls > I/O
Configuration > Analog Input Config > select Channel > select
Point >
User Value
.
TABLE POINT 01 USER VAL:
CURRENTLY: 0.00
SET TO: 00000.0
0
MOVE CURSOR
CHANGE VALUE SAVE
RANGE AVG DIAGS ALARM
The Screen Contrast screen is used to change the contrast of the display.
Intensities between 0 and 100% in increments of 5 are available.
Changing the screen contrast may be necessary if the instrument is
operated at extreme temperatures.
Note The optimal contrast will change with changes in temperature.
s
Note
The optimal contrast will change from one LCD to another. If the
LCD is replaced, the contrast may need to be reset.
s
If the display contrast is not optimal, but the content on the screen is
visible, select Instrument Controls >
Screen Contrast
and adjust the
screen contrast. If the content on the screen is not visible, use the “set
contrast 10” C-Link command to set the screen contrast to mid-range,
then optimize the contrast. See “contrast levels” in Appendix B, “ C-Link
Protocol Commands ” for more information on this command.
s
l
In the Main Menu, choose Instrument Controls > Screen Contrast .
SCREEN CONTRAST:
CURRENTLY: 50 %
SET TO: 55 % ?
CHANGE VALUE
SAVE VALUE
RANGE AVG DIAGS ALARM
User Value
Screen Contrast