Thermo Scientific 5028i, Инструкция по эксплуатации, Страница: 293 / 330

C-Link Protocol Commands
Communications Configuration
Thermo Fisher Scientific Model 5028
i
Instruction Manual B-53
instr name
This command reports the instrument name. The following example
reports the instrument name for the Model 5028 i .
Send: instr name
Receive: instr name
Beta
Particle Analyzer
instrument id
This command reports the instrument identification (ID). The following
example reports the current setting of the instrument ID.
Send: instrument id
Receive: instrument id 14
set instrument id value
This command sets the instrument ID to value , where value is an
integer between 0 and 127 inclusive. The following example shows the
instrument ID changed to 12.
Note
Sending this command via RS-232 or RS-485 will require the
host to use the new ID for subsequent commands.
s
Send: set instrument id 12
Receive: set instrument id 12 ok
layout ack
This command reports the stale layout/layout change indicator (*) that
is attached to each response if the erec layout has changed since the last
time erec layout was requested, according to Table B–9 . The following
example reports that the instrument is configured to do nothing.
Send: layout ack
Receive: layout ack 0
set layout ack
value
This command disables the stale layout/layout change indicator (*) that
is attached to each response if the erec layout has changed since the last
time erec layout was requested, according to Table B–9 .
Send: set layout ack
Receive: set layout ack ok