Ross Synergy 100 MD, Руководство оператора

Страница: 319 / 402

Synergy 100 MD Operator’s Manual (v7.2 MD-S100) Lighting
•
18–3
Lighting Setup
This section describes how to adjust the following parameters:
• Lighting Model
• Position
• Presets
• Auto Follow
• Luminance Clipping
Lighting Model
Use the following procedure to select the type of lighting:
1. Navigate to the Lighting Menu as follows:
• Press
FLY KEY
in the Effects Keyers Group .
• Press
SEL/DVE
+
Light
to display the Lighting Menu .
2. Set the
Lighting Setup
option by toggling
0. Lighting Setup
to one of the
following:
•
None
— Use this option to turn the lighting model off. If the source is set to None ,
the lighting parameters are not enabled.
•
Natural
— Use this option to enable the lighting model.
Lighting Setup — Lighting Menu
3. Adjust the lighting using the following knobs:
• Use the
HUE
knob, or move the Positioner left and right , to adjust the intensity of
the directional light.
• Use or
SAT
knob, or move the Positioner up and down , to adjust the ambient light
level. For increased shadows and high contrast, use a low Ambient light level.
This completes the procedure to select the type of lighting.
Operating
Tip
To give the image a more “flattened” effect, increase the Ambient light
level. To rely exclusively on directional light, set the Ambient light to
zero.
Use positioner or Hue, Sat, Lum to modify
Lighting Key 1
Natural
On
Lighting Setup
Intensity: 31.9%
Ambient: 55.0%
12
0. Lighting Setup
1. Position
2. Presets
3. Auto Follow
4. Luminance Clipping