Ross Synergy 100 MD, Руководство оператора

Страница: 307 / 402

Synergy 100 MD Operator’s Manual (v7.2 MD-S100) Squeeze & Tease MD Sequences and Wipes • 17–31
~ Cropping the image horizontally, vertically, or both until it appears to disappear
from view.
Sometimes the image needs to travel further to get off screen than at other times
(depending on its starting location). When you use a preset, for example,
Slide Off , the
system creates a virtual “last Keyframe” to put the image where it should be in order to
move it off screen.
7. Save your changes as follows:
• Press
0. Load/Save Seq.
to display the Load/Save Sequence Menu .
• Use the knobs to select a position in the list.
• Press
1. Save Sequence
to save the wipe.
This completes the procedure to create a Squeeze & Tease Wipe.
The system does not differentiate between sequence memories and wipe memories. It is suggested
that you give each wipe a unique descriptive name to make it easy to identify. Refer to the section
“
Renaming a Sequence ” on page 17–21 for information on renaming sequences.
Loading a Squeeze & Tease Wipe
Use the following procedure to load any of the available Squeeze & Tease Wipes:
1. Navigate to the Sequence Menu as follows:
• Press FLY KEY in the Effects Keyers Group to display the S&T MD Menu .
• Press 2. Sequences to display the Sequence Menu .
Sequence Menu
2. Press 0. Load/Save Sequence to display the Load/Save Sequence Menu .
3. Use the knobs, or the positioner, to select the sequence from the list.
4. Press 0. Load Sequence . The sequence appears in the workspace.
This completes the procedure to load any of the available Squeeze & Tease Wipes.
Note When you use the None modifier, the system does not compensate for
the starting position of the image when the wipe is applied. It runs the
pattern exactly as it was set up.
Operating
Tip
Like sequences, Squeeze & Tease Wipes can contain Holds that pause
playback until you press the AUTO TRANS button. Refer to the
section “ Adding a Hold to a Sequence ” on page 17–18 for
information on inserting a Hold into your wipe.
MENU
Exit 100
Previous 10
Down SEL
Accept 1
Up
Sequence Key 1
0. Load/Save Sequence
1. Previous Keyframe
2. Next Keyframe
3. Insert Keyframe
4. Overwrite Keyframe 5. Delete Keyframe
6. Delete Workspace
7. Wipe Modifier
8. Reserved
9. Keyframe Parameters
**EMPTY**