Ross Synergy 100 MD, Руководство оператора

Страница: 311 / 402

Synergy 100 MD Operator’s Manual (v7.2 MD-S100) Squeeze & Tease MD Sequences and Wipes • 17–35
Dest/Source Menu
3. Select the storage device you want to use to store your set of sequences to as follows:
• Press
0. Dest/Source
.
• Use the
ª
and
©
buttons to select the storage device you want to use. You can
select between the following:
~
Hard Drive
— This option will allow you to store the files on the internal hard
drive. There are 100 (
00
through
99
) setups available to store files.
~ USB — This option will allow you to recall the files from a USB Drive. You
must wait 5 seconds after inserting the USB Drive into the USB Port before
you can save or recall files. Refer to the section “
Notes on Using a USB
Drive ” on page 9–16 for further information.
4. Select a setup, or location, for the storage of the files as follows:
• Press 1. Set Names .
• Use the
ª
and
©
buttons to select the Setup you want to use. You can select from
SETUP (00) to SETUP (99) .
5. Press
BACK
to display the Disk Menu .
6. Press
1. Store
to display the Store Menu .
Store Menu
7. Press
5. Store Indiv. 3D Wipe
to display the Store Individual Items Menu .
8. Select the sequence and the location to save it to as follows:
• Use the
HUE
knob to select the switcher sequence number that you want to save to
the storage device.
• Use the SAT knob to select the storage device location for the sequence you want to
save.
MENU
Exit 100
Previous 10
Down SEL
Accept 1
Up
Dest/Source
0. Dest/Source
1. Set Names Hard Drive
SETUP(00)
MENU
Exit 100
Previous 10
Down SEL
Accept 1
Up
Hard Drive: SETUP(00)
Store
0. Reserved
1. Store Memories
2. Store Personality
3. Store Installation
4. Store 3D Wipes 5. Store Indiv 3D Wipe
6. Store Bus Map