Ross Synergy 100 MD, Руководство оператора

Страница: 327 / 402

Synergy 100 MD Operator’s Manual (v7.2 MD-S100) WARP Effects
•
19–3
WARP Resources
A WARP card installed in your switcher provides a single WARP resource. WARP resources are used
when applying WARP effects to three areas corresponding to the Background, Key 1, and Key 2
buses. One WARP resource is required to deliver a WARP effect in any of the three areas and only one
WARP resource can be used in each area at a time. There is one notable exception: when a WARP is
used as a wipe transition on the background bus and either or both Key 1 and Key 2, only a single
WARP resource is used. This allows you to apply a WARP to a key and use a second WARP as a wipe
transition on that key as long as the background is set to transition as well.
The table below illustrates various scenarios and the number of WARP resources required.
Freeing WARP Resources
If you try to use a WARP effect when all the WARP resources are in use, a warning message appears
on your menu allowing you to choose how the resource conflict is resolved.
Freeing Resources
You have the following options:
• 0. WARP 1 — Frees the first WARP resource from whatever effect it is being used for
and applies it to the new effect.
• 5. Cancel — Does not free either WARP resource. The new effect is not performed.
WARP Resources Used under Various Scenarios
Scenario WARP
Resources
Required
Applying a WARP Effect to a key 1
Running a Sequence containing a WARP effect on a key 1
Running a Squeeze & Tease MD Wipe with a WARP effect on...
• Background bus 1
• Background bus + Key 1 Bus 1
• Background bus + Key 2 Bus 1
• Background bus + Key 1 and Key 2 Bus 1
• Key 1 Bus 1
• Key 2 Bus 1
• Key 1 + Key 2 Bus 2
Warning! Key 1
Warps are currently in use:
Warp 1 - Used by MLE 1 - Key 1
Warp 2 - Used by MLE 1 - Key 2
Do you wish to free a Warp resource?
0. Warp 1 5. Cancel
1. Warp 2