Ross Synergy 100 MD, Руководство оператора

Страница: 310 / 402

17–34 • Squeeze & Tease MD Sequences and Wipes Synergy 100 MD Operator’s Manual (v7.2 MD-S100)
you can save or recall files. Refer to the section “ Notes on Using a USB
Drive ” on page 9–16 for further information.
4. Select a setup, or location, for the storage of the files as follows:
• Press
1. Set Names
.
• Use the
ª
and
©
buttons to select the Setup you want to use. You can select from
SETUP (00)
to
SETUP (99)
.
5. Press
BACK
to display the Disk Menu .
6. Press
1. Store
to display the Store Menu .
Store Menu
7. Press 4. Store 3D Wipes .
8. Confirm saving the wipes to a storage device or cancel the procedure as follows:
• Press
0. Yes
to save the wipes.
• Press
1. No
to exit the menus, without saving the wipes to a storage device.
This completes the procedure to store the entire set of sequence registers as one file.
Storing Individual Squeeze & Tease Sequences
When you save a specific 3D sequence, it is saved as a single file named STSEQ##.TZA . The ## is
the number of the sequence you have selected to store to a storage device.
Use the following procedure to store a specific 3D sequence:
1. If you are using a USB Drive, plug it into the USB port on the front of the switcher. Wait
at least 5 seconds to allow the system to recognize the USB Drive.
2. Navigate to the Dest/Source Menu as follows:
• Press MENU to display the Main Menu .
• Press 5. Disk to display the Disk Menu .
• Press 0. Dest/Source to display the Dest/Source Menu .
Caution Do NOT remove a USB Drive from the switcher before the LED on
the USB port goes out. Doing so may destroy the data on your USB
Drive, as well as the data on the next one you insert into the USB port.
MENU
Exit 100
Previous 10
Down SEL
Accept 1
Up
Hard Drive: SETUP(00)
Store
0. Reserved
1. Store Memories
2. Store Personality
3. Store Installation
4. Store 3D Wipes 5. Store Indiv 3D Wipe
6. Store Bus Map