Renesas H8S/2318 series, Руководство по оборудованию

Страница: 631 / 1121

Rev. 5.00, 12/03, page 601 of 1088
CE
A
18
to A
0
I/O
7
to I/O
0
VIH
OE
WE
t
ce
t
acc
t
oe
t
oh
t
oh
t
df
t
ce
t
acc
t
oe
Address stable Address stable
t
df
Figure 17-25 Timing Waveforms for
CE CE CE CE
/
OE OE OE OE
Clocked Read
17.11.5 Auto-Program Mode
•
In auto-program mode, 128 bytes are programmed simultaneously. For this purpose, 128
consecutive byte data transfers should be performed.
•
A 128-byte data transfer must be performed even if writing fewer than 128 bytes; in this case,
H'FF data must be written to the extra addresses.
•
The lower 7 bits of the transfer address must be held low. If an invalid address is input,
memory programming will be started but a programming error will occur.
•
Memory address transfer is executed in the second cycle (figure 17-26). Do not perform
transfer later than the second cycle.
•
Do not perform a command write during a programming operation.
•
Perform one auto-programming operation for a 128-byte block for each address. One or more
additional programming operations cannot be carried out on address blocks that have already
been programmed.
•
Confirm normal end of auto-programming by checking I/O
6
. Alternatively, status read mode
can also be used for this purpose (the I/O
7
status polling pin is used to identify the end of an
auto-program operation).
•
Status polling I/O
6
and I/O
7
information is retained until the next command write. As long as
the next command write has not been performed, reading is possible by enabling
CE
and
OE
.