Renesas H8S/2318 series, Руководство по оборудованию

Страница: 252 / 1121

Rev. 5.00, 12/03, page 222 of 1088
P1DR is initialized to H'00 by a reset, and in hardware standby mode. It retains its prior state after
in software standby mode.
Port 1 Register (PORT1)
Bit : 7 6 5 4 3 2 1 0
P17 P16 P15 P14 P13 P12 P11 P10
Initial value : —
*
—
*
—
*
—
*
—
*
—
*
—
*
—
*
R/W : R R R R R R R R
Note: * Determined by state of pins P17 to P10.
PORT1 is an 8-bit read-only register that shows the pin states. It cannot be written to. Writing of
output data for the port 1 pins (P17 to P10) must always be performed on P1DR.
If a port 1 read is performed while P1DDR bits are set to 1, the P1DR values are read. If a port 1
read is performed while P1DDR bits are cleared to 0, the pin states are read.
After a reset and in hardware standby mode, PORT1 contents are determined by the pin states, as
P1DDR and P1DR are initialized. PORT1 retains its prior state after in software standby mode.
Port Function Control Register 1 (PFCR1)
Bit : 7 6 5 4 3 2 1 0
CSS17 CSS36 PF1CS5S PF0CS4S A23E A22E A21E A20E
Initial value : 0 0 0 0 1 1 1 1
R/W : R/W R/W R/W R/W R/W R/W R/W R/W
PFCR1 is an 8-bit readable/writable register that performs I/O port control. PFCR1 is initialized to
H'0F by a reset, and in hardware standby mode.
Bit 7—CS17 Select (CSS17): Selects whether
CS1
or
CS7
is output from the PG3 pin. For
details, see section 8.12, Port G.
Bit 6—CS36 Select (CSS36): Selects whether
CS3
or
CS6
is output from the PG1 pin. For
details, see section 8.12, Port G.
Bit 5—Port F1 Chip Select 5 Select (PF1CS5S): Selects enabling or disabling of
CS5
output.
For details, see section 8.11, Port F.
Bit 4—Port F0 Chip Select 4 Select (PF0CS4S): Selects enabling or disabling of
CS4
output.
For details, see section 8.11, Port F.