Renesas H8S/2318 series, Руководство по оборудованию

Страница: 279 / 1121

Rev. 5.00, 12/03, page 249 of 1088
8.6.2 Register Configuration
Table 8-9 shows the port A register configuration.
Table 8-9 Port A Registers
Name Abbreviation R/W Initial Value
*
1
Address
*
2
Port A data direction register PADDR W H'0 H'FEB9
Port A data register PADR R/W H'0 H'FF69
Port A register PORTA R Undefined H'FF59
Port A MOS pull-up control register PAPCR R/W H'0 H'FF70
Port A open-drain control register PAODR R/W H'0 H'FF77
Notes: 1. Value of bits 3 to 0.
2. Lower 16 bits of the address.
Port A Data Direction Register (PADDR)
Bit : 7 6 5 4 3 2 1 0
— — — — PA3DDR PA2DDR PA1DDR PA0DDR
Initial value : Undefined Undefined Undefined Undefined 0 0 0 0
R/W : — — — — W W W W
PADDR is an 8-bit write-only register, the individual bits of which specify input or output for the
pins of port A. PADDR cannot be read; if it is, an undefined value will be read. Bits 7 to 4 are
reserved.
PADDR is initialized to H'0 (bits 3 to 0) by a reset and in hardware standby mode. It retains its
prior state after in software standby mode. The OPE bit in SBYCR is used to select whether the
address output pins retain their output state or become high-impedance when a transition is made
to software standby mode.
•
Modes 4 and 5
The corresponding port A pins are address outputs irrespective of the value of bits PA3DDR to
PA0DDR.
•
Mode 6*
Setting PADDR bits to 1 makes the corresponding port A pins address outputs, while clearing
the bits to 0 makes the pins input ports.