Polaris RZR 570 2013, Руководство по обслуживанию

Страница: 124 / 482

3.52
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
CYLINDER HONE SELECTION / HONING
PROCEDURE
CAUTION
Selecting a hone which will straighten as well as
remove material from the cylinder is very important.
Using a common spring loaded finger type glaze
breaker for honing is never advised. Polaris
recommends using a rigid hone or arbor honing
machine which also has the capability of oversizing.
Cylinders may be wet or dry honed depending upon the
hone manufacturer’s recommendations. Wet honing
removes more material faster and leaves a more distinct
pattern in the bore.
CLEANING THE CYLINDER AFTER HONING
It is very important that the cylinder be thoroughly
cleaned after honing to remove all grit material. Wash the
cylinder in a solvent, then in hot, soapy water. Pay close
attention to areas where the cylinder sleeve meets the
aluminum casting. Use electrical contact cleaner if
necessary to clean these areas. Rinse thoroughly, dry
with compressed air, and oil the bore immediately with
engine oil.
CAMSHAFT INSTALLATION / TIMING
NOTE
If any valve train components were replaced, refer to
“Valve Clearance Adjustment”, page 3.63 procedure
prior to “Camshaft Installation / Timing”.
1. Rotate the engine and position the piston at TDC.
2. Reference the intake
q
and exhaust
w
markings
made during disassembly.
3. Lubricate all camshaft lobes and bearing journal
surfaces with Polaris PS-4 engine oil prior to
installation.
4. Place the exhaust cam into the cylinder head and
align the timing marks as shown below.
5. Wrap the cam chain around the exhaust cam
sprocket and hold the exhaust cam in its current
position.
ENGINE / COOLING SYSTEM