Polaris RZR 570 2013, Руководство по обслуживанию

Страница: 109 / 482

3
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
3.37
30. Install the left-hand rear wheel and torque wheel nuts
to specification.
TORQUE
Wheel Nuts:
Steel Rims: 27 ft-lbs (37 Nm)
Aluminum Rims: 30 ft-lbs (41 Nm) + 90°
31. Remove the pressure cap and fill the cooling system
through the filler neck with properly mixed anti-freeze
/ coolant.
32. If the engine oil was completely drained, add
approximately 2 quarts (1.9 L) of Polaris PS-4
Synthetic Engine Oil into the crankcase.
33. Install a new oil filter. Lubricate the seal with engine
oil prior to installation (see Chapter 2 – Engine Oil
and Filter Service, page 2.11).
34. Connect the (-) negative battery cable to the battery.
35. Install the engine service panel and seats.
36. Follow the “Cooling System Bleeding Procedure” as
outlined in this chapter.
37. Start engine and check for any oil or coolant leaks.
38. Check the engine oil level (see Chapter 2 – Engine
Oil Level, page 2.11).
39. Refer customer to Engine Break-In Period, page
3.37 upon returning vehicle to customer.
ENGINE BREAK-IN PERIOD
The break-in period consists of the first 25 hours of
operation, or the time it takes to use 15 gallons (57 liters)
of fuel. Careful treatment of a new engine and drive
components will result in more efficient performance and
longer life for these components.
CAUTION
Use only Polaris PS-4 Synthetic Engine Oil.
Never substitute or mix oil brands. Serious engine
damage can result.
Do not operate at full throttle or high speeds for
extended periods during the first three hours of use.
Excessive heat can build up and cause damage to
close fitted engine parts.
1. Fill fuel tank with unleaded fuel which has a minimum
pump octane number of 87 = (R+ M)/2.
2. Refer to Chapter 2, “Engine Oil Level”. Check oil
level indicated on oil tank dipstick. Add oil if
necessary.
3. Drive slowly at first to gradually bring engine up to
operating temperature.
4. Vary throttle positions. Do not operate at sustained
idle or sustained high speed.
5. Perform regular checks on fluid levels, controls and
all important bolt torques.
6. Change oil and oil filter after break-in period at 25
hours.
ENGINE / COOLING SYSTEM