Oxford Instruments Cypher SPM, Руководство пользователя

Страница: 86 / 243

Cypher SPM
User Guide
10.9.2 Prepare the scanner
1. Remove the cantilever holder and place it, cantilever tip facing upwards, to the side.
See the four steps beginning with Loading the cantilever and sample on an environmental scan-
ner on page 205
2. Prepare scanner for removal.
l
Raise the coarse engage stage by turning the Engage
Control Knob clockwise.
l
Raise the stage until it reaches its upper limit of
travel.
This prepares the engage mechanism for a later step of
installing a heated temperature stage.
3. Turn off the ARC2 controller power, remove the scanner from the Cypher Chassis, and place it
on a well lighted clean work surface.
See Removing the scanner on page 109 .
10.9.3 Remove the sample stage and chamber
1. Loosen the sample stage clamping screw.
l
Insert the 5/64” hex driver into the screw hole at the
front of the scanner.
l
Turn the hex driver counterclockwise at most THREE
full rotations to loosen sufficiently. Turning the lock-
ing screw (114.576) more than three turns may cause
the screw to come all the way out.
Tip: If the screw comes all the way out, you may
need to lean the scanner forward until the screw
slides out to a place where you can put it back on
the wrench.
2. Loosen the cell body screws.
l
Use the 5/64” hex driver to loosen the screws at the
top of the cell body.
l
Set the screws aside.
l
Extra screws are available in your kit. Replace old
screws with Item 20, 2-56 x 1/8” long screws (Asylum
Part #SHCS SS).
10 Cell Body and Sample Stage Guide Page 86 of 243