M2DC Series Hardware Manual
62
Rev. 1.1
2018/04
400-820-9661
5.6 Parameter Setting Mode
5.6.1 Parameter Setting Description
The parameter setting mode (P+parameter number) allows you to select, display and edit the required
parameter. In function control mode, press and hold
for 1 second to enter parameter setting mode.
Use
to select required parameter, and press
to view or edit the parameter. Press
again to quit and no change will be saved. Press and hold
for 1 second to save the parameter
change. However this change will NOT be saved at the next power on.
If you want to save parameter PERMANENTLY, go into function control mode (F+parameter number), and
use F-04SA function.
parameter setting
selection
Press UP and DOWN key
to select display detail.
S
press SET key to
enter parameter editing mode
press and hold SET key
to save parameter change
S
short press SET key
to quit
function selection
mode
M
press and hold MODE key
for 1 second
