Mitsubishi FR-A740-00023-EC, Инструкция по эксплуатации

Страница: 397 / 474

387
Parameter copy and parameter verification
4
P
ARAME
T
E
R
S
4.30.2 Parameter verification
appears...Why? Parameter read error. Perform operation from step 3 again.
appears...Why? Parameter write error. Perform operation from step 8 again.
and flicker alternately
Appears when parameters are copied between the inverter of 01800 or less and 02160 or more.
1. Set "0" (initial value) in
Pr. 160 User group read selection .
2. Set the following setting (initial value) in
Pr. 989 Parameter copy alarm release
.
3. Reset Pr. 9, Pr. 30, Pr. 51, Pr. 52, Pr. 54, Pr. 56, Pr. 57, Pr. 61, Pr. 70, Pr. 72, Pr. 80, Pr. 82, Pr. 90 to Pr. 94 , Pr. 158,
Pr. 455, Pr. 458 to Pr. 462, Pr. 557, Pr. 859, Pr. 860, Pr. 893 .
Whether same parameter values are set in other inverters or not can be checked.
REMARKS
When the copy destination inverter is not the FR-A700 series, "model error ( )" is displayed.
flickers ... Why?
Set frequencies, etc. may be different. Check set frequencies.
01800
or less
02160
or more
Pr. 989 Setting 10 100
•
Hold down to verify.
2.
Screen at powering on
The monitor display appears.
Display
Operation
7.
Press to read the parameter setting
of the verified inverter to the operation panel.
1.
Replace the operation panel on the
inverter to be verified.
•
Replace it during a stop.
Flicker ··· Parameter verification complete!!
4.
Turn until (parameter copy)
appears.
6.
Turn to change it to the set value
" "(parameter copy verification mode).
8.
It there is no difference, " " and " "
flicker to complete verification.
Flickers for about 30s
Flickering
•
If different parameters exist, different
parameter numbers and flicker.
The parameter
number read
previously appears.
5.
Press to read the currently set
value.
" "(initial value) appears.
3.
Press to choose the parameter
setting mode.