MIMAKI TextileJet Tx2-1600 Series, Руководство по эксплуатации

Страница: 85 / 154

- 2.9 -
IF THERE ARE FAINT OR MISSING PORTIONS IN INK DISCHARGE
CONDITION
Cleaning ink heads
If a test pattern plotted is defective, execute the cleaning function to clean the associated ink head.
After cleaning the ink head, make the device plot a test pattern again. If the test pattern is defective
too, re-clean the ink head. Continue executing the cleaning function till a normal test pattern is
obtained.
• If a normal test pattern cannot be obtained even after the cleaning function
is executed many times, clean the ink station interior (See page 4.8).
soft : Select this if there is any missing line.Cleaning is carried out for
a short period of time.
normal : Select this if any line is bent. Cleaning is carried out for a long
period of time and a large amount of ink is consumed.
strong : Select this if there are many missing portions.
STEP
1. The device enters the LOCAL mode.
(See page 1.24)
2. Push the [CLEANING] key.
(See page 1.41)
3. Select the ink head to be cleaned by pushing
the JOG keys [ ] [ ] [ ] and [ ].
Each time a JOG key is pushed, the row of heads to be
cleaned changes from R to F (or F to R). The upper eight of
test printing indicates the R row of heads, and the lower eight
indicates the F row of heads.
4. Push the [ENTER] key.
5. Select the method of cleaning by pushing the
JOG keys [ ] and [ ].
6. Push the [ENTER] key.
Cleaning starts. As the cleaning proceeds, asterisks (*) are
displayed in succession on the LCD. At the end of the
cleaning, the two lines of the LCD panel are filled with
asterisks.
7. The device enters the LOCAL mode.
<< LOCAL >>
width : 1272mm
CLEANING : 12345678
SELECT : ABCDEFGH
CLEANING : - - - - 5678
SELECT : ABCDEFGH
CLEANING : - - - - 5678
SELECT : ABCDEFGH
CLEANING
TYPE
: normal
CLEANING
TYPE
: soft
CLEANING ACTIVE
* * * * * * - - - - - - - - - -
<< LOCAL >>
width : 1272mm