MIMAKI TextileJet Tx2-1600 Series, Руководство по эксплуатации

Страница: 10 / 154

- vi -
PRECAUTIONS IN USE
CAUTION
Locking the caster of stand
• Be sure to lock the caster of stand
before starting printing. If the
device performs printing without
locked, the device can move out
of position.
Front cover and lever
• Never open the front cover and/or
lever during printing. Opening
the cover or lever will abort
printing.
Protection against dust, waste paper and
flocks
• Keep the front cover held closed
also when the device is not
engaged in printing. If not, dust
can accumulate on the head
nozzle.
• When leaving the workshop after
the working hours, be sure to
remove any fabric from the roll
hanger. If any fabric is left on the
roll hanger, dust can gather on it.
• Store fabric in a bag. Wiping off
dust, waste paper and flocks.
accumulated on a fabric will
adversely affect the fabri due to
static electricity.
• Frequently wipe the capping
station clean to eliminate dust
and paper chips. Wiping with a
fluffy wiper only rubs dust over
the capping station. Replace the
fluffy wiper immediately with a
new one.
• Dust,waste paper and flocks in
the head will also cause drops of
ink to fall abruptly down on the
fabric during printing. If this
phenomenon takes place, be
sure to clean up the head. (See
“Chapter 4 Maintenance
functions.”)
Periodic exchange parts
• There are some parts which
must be replaced by service
men after Tx2-1600 are in use
for 5000 hours from 3000 hours.
Therefore, we would like to
suggest that you make a
contract with distributors or
dealers for after-sale service.
Fabric
• Use specific fabric designated
fabric exclusive to Tx2-1600.
Mimaki assumes no
responsibility for any damage
caused by the use of any fabric
other than the afore-mentioned
one.
• If fabric that is likely to tightly
curl, flatten first the fabric
before using it for printing.
Heavily-curled fabric affect the
plotted picture quality.
Locking the casters
• Be sure to lock the casters
before starting printing. If the
device performs printing without
the casters locked, the device
can move out of position.
Warning labels
• This device is adhered with a
warning label at two locations.
Be sure to fully understand the
warnings given on the labels.
In the case where any of the
warning label has become so
soiled that the warning message
is illegible or has come off,
purchase a new one from your
local distribu-tor or our office.
Refer to Appendix for the label
adhering locations.