MIMAKI TextileJet Tx2-1600 Series, Руководство по эксплуатации

Страница: 57 / 154

- 1.37 -
BEFORE SETTING THE FABLIC ON THE DEVICE
Adjusting the head height when the fablic used is changed [HEAD HEIGHT]
When changing to the fabric of other kinds, it is necessary to adjust the head height according to the
thickness of the new fabric.
If the height of the head is inappropriate to the thickness of the fabric, the plotter cannot work
properly.
More important, operating without adjusting the head height is very dangerous: it can damage the
fabric and the plotter.
When a new fabric different in thickness from the current fabric is to be used, be sure to make
proper adjustment of the head height.
•
[HEAD HEIGHT] is a function to set the distance between the fabric sur-
face and head to 3mm.
• Adjust the head height before setting the fabric on the device.
If an attempt is made to adjust the head height with the fabric kept set on
the platen, the fabric gets caught on the carriage during “carriage out”
operation, causing damage to the head.
• If you set the head height to 1.1mm (minimum value) from the platen
surface, note the following points:
•
Remove the fabric pressers. If they are used, the head knocks up
against the fabric pressers, which may cause damage to the device.
• Use fabrics without wrinkle or uneven surface. If a fabric with wrinkle
or uneven surface is used, the head may rub or catch the fabric to
push it to a position resulting in fabric jam.
• Except for cases when using film or other flat thin fabric, set the head
height to 3mm.
•
Before performing [CARRIAGEout], be sure to move down the clamp lever
on the front side of this device.
Performing [CARRIAGEout] with the clamp lever moved up may cause the
head to hit the pinch roller damaging them.
STEP
1. Move down the clamp lever on the front face
on the plotter
2. Enter into the FUNCTION mode.
(See to Page.4-3)
3. Push the [ENTER] key.
FUNCTION
MAINTENANCE
< ENT >
MAINTENANCE
LIST
< ent >