LSIS 6731001500, Руководство пользователя

Страница: 96 / 659

83
Learning Basic Features
Basic Tasks Description Ref.
reaches the defined frequency, DC braking is applied.
Free-run stop
Configures the inverter to stop output to the motor using
a stop command. The motor will free-run until it slows
down and stops.
p.135
Power braking
Configures the inverter to provide optimal, motor
deceleration, without tripping over-voltage protection.
p.136
Start/maximum frequency
configuration Configures the frequency reference limits by defining a
start frequency and a maximum frequency.
p.137
Upper/lower frequency limit
configuration Configures the frequency reference limits by defining an
upper limit and a lower limit.
p.137
Frequency jump
Configures the inverter to avoid running a motor in
mechanically resonating frequencies.
p.140
2 nd Operation Configuration
Used to configure the 2
nd
operation mode and switch
between operation modes according to your
requirements.
p.141
Multi-function input
terminal control
configuration
Enables the user to improve the responsiveness of the
multi-function input terminals.
p.142
4.1 Switching between the Operation Modes (HAND /
AUTO / OFF)
The H100 series inverters have two operation modes–the HAND and AUTO modes. HAND mode is
used for local control using the keypad. AUTO mode is used for remote control using the terminal
inputs or networks commands (the keypad may still be used in AUTO mode if the command
source is set as ‘keypad’).
HAND Mode Operation
Follow the instructions listed below to operate the inverter in HAND mode.
1
On the keypad, use the [Up], [Down], [Left], or [Right] keys to set the frequency reference.
2
Press the [HAND] key. The HAND LED turns on and the inverter starts operating in HAND
mode.