Katronic Technologies FLUXUS ADM 6725, Инструкция по эксплуатации

Страница: 45 / 148

ADM 6725 E10

KA T
5 - 3
Program Branch MEASURING
+
O
provides the total quantity
for positive flow direction.
Key
E NT E R
will return you to M6.
Key
152
provides further information on the lower display line.
Key
ISP
provides further information on the upper display line.
At any point, key
B R K
ends the measuring mode and returns to the MAIN MENU.
5.2 Measurement Preparation
By now, you should have completed the input of the necessary parameters for every
available measuring channel. However, the correct position for the transducers on the
pipe wall can only be found by you. FLUXUS will assist you and make suggestions for:
•
the mounting configuration for the transducer installation (reflection or diagonal mode),
•
the transducer distance,
•
the quality of the received sound signal.
There is no need for special measuring equipment, such as oscilloscopes, to position the
transducers.
Measuring
par>MEA< opt sf
M1
Select and confirm in the MAIN MENU the
program branch MEASURING.
MEASUR
√
- . .
CHANN:>A<B Y Z
√
=
The measuring channel has been
activated.
M3
This first display of the program branch MEA
requests the activation/deactivation of the
available measuring channels.
"
Select the measuring channel.
O N
O
activates the channel.
−
=
The measuring channel has been
deactivated.
•
=
The measuring channel cannot be
activated. No data have been entered
under the PARAMETER submenu.
O F F
O
deactivates the channel.
(A deactivated
channel will be ignored during the measurement. All
parameters entered for this channel will remain
unchanged.)
Confirm by pressing ENTER.
Note:
A measuring channel cannot be activated if
•
the channel does not exist,
•
parameters are not valid (if, e.g., the program branch PAR for the respective
measuring channel has not been worked through completely).