Katronic Technologies FLUXUS ADM 6725, Инструкция по эксплуатации

Страница: 94 / 148

8 - 8
ADM 6725 E10

KA T
Measuring Data Transfer to PC
\STOP MEASURE AT : date/time Automatic termination of measurement
\LOWBAT date/time Measurement stopped because of low battery power
\RUN date/time There was an interruption in storing the measured values in
memory, but storage continued as per date/time stamp.
(5) Should you have more than one measuring data set stored in memory: See point (2)
above again.
Note: All valid entries of stored measuring data will be output.
Example: Temperature T1 cannot be measured during heat flow measurement:
An ´?UNDEF´ will appear in the ASCII-file in the respective column for T1. Since without T1 the heat
flow cannot be calculated, the characters ´???´ are written in the column MEASURE. However, T2 and
the flow velocity (/VL+) will be output if the measurements for them could be obtained.