Katronic Technologies FLUXUS ADM 6725, Инструкция по эксплуатации

Страница: 20 / 148

2 - 6
FLUXUS ADM 6725 E10

KA T
Description of Flowmeter
Attention!
If the key combination has been initiated, the display appears in the
factory pre-set language version again.
2.3.3 HotCodes
HotCodes are key sequences in order to call up specific operational modes/set-
ups of FLUXUS.
(The previous chapter dealt with the key sequences, which form the so-called HotCode, to select a
specific language.)
HotCodes can be entered, when FLUXUS displays the MAIN MENU after
switching ON.
The following table gives an overview of the most important HotCodes:
HotCode See
chap-ter
Mode/set-up Will this mode
remain activated
after switching the
unit OFF?
Will this mode
remain activated
after a cold start
(INIT)?
How to de-activate the
mode/set-up done by
HotCode
9 0 9 0 4 4
9 0 9 0 4 9
2.3.2 Display language:
English
German
(other language codes,
see chapter 2.3.2)
Yes No,
the factory pre-set
display language
appears again
(default language).
Enter the code of another
language.
0 7 1 0 4 9 13.1 Activation of Super User
Mode
No No Switch FLUXUS OFF.
2 3 2 8 8 8 14.5 Change of serial protocol
for graphics printing
Yes Yes Enter the same code.
0 0 7 0 0 1 19.1 Enable or disable time
programmable
measuring mode
Yes Yes Enter the same code.
0 0 7 0 0 2 15.4 Enable or disable offset
correction facility for heat
quantity measurement
Yes Yes Enter the same code.
0 0 7 0 0 3 5.4.2 Change of data storage
mode for data logging of
measured values
Yes Yes Enter the same code.
0 0 7 0 0 4 5.4.3 Change of data storage
mode for total quantity
counters
Yes Yes Enter the same code.
0 0 7 0 0 5 5.4.1 Change profile
correction for 'Flow
velocity' measurement
Yes Yes Enter the same code.
0 0 7 0 0 8 11.3 Basic unit selection for
the measurement of heat
quantity
Yes Yes Enter the same code.
0 0 7 0 0 9 5.2.1 Definitions for
description of measuring
point
Yes Yes Enter the same code.
0 7 1 0 0 0 4.3.5 Change of parameter
limit for transducers of
type ‘Q’
(Set-up of low limit for inner pipe
diameter)
Yes Yes Enter the same code.
0 7 1 0 0 0 5.3.3 Set-up of limit for cut-off
flow velocity
Yes Yes Enter the same code.
2 3 2 0 0 0 6.6 Set-up for data format of
serial output
Yes Yes Enter the same code.
0 0 6 9 9 9 See next
page
Sequential display of
inputs, which can be
called by HotCodes
separately
No Yes Switch FLUXUS OFF.