Juniper QFX3000-G QFabric, Руководство по развертыванию, Страница: 359 / 652

•
Connect the Director devices to each other and create a Director group. Connect one
port from each network module on the first Director device to one port in each network
module on the second Director device.
Figure 62 on page 229 shows the specific ports on the Director group that you must connect
to the Virtual Chassis and interconnect between the Director devices.
Figure 83: QFX3000-G QFabric System Fiber-Based Control
Plane—Director Group to Virtual Chassis Connections
VC0 VC1
DG0
DG1
0 1 2 3 0 1 2 3
To port 22 To port 23 To port 23 To port 22
0 1 2 3
Patch cables
between Director devices
0 1 2 3
In this specific example, connect ports 0, 1, and 2 from module 0 on Director device DG0
to port 22 on Virtual Chassis VC0 (ge-0/0/22, ge-1/0/22, and ge-2/0/22), and connect
ports 0, 1, and 2 from module 1 to port 22 on Virtual Chassis VC1 (ge-0/0/22, ge-1/0/22,
and ge-2/0/22).
For Director device DG1, connect ports 0, 1, and 2 from module 0 to port 23 on Virtual
Chassis VC0 (ge-0/0/23, ge-1/0/23, and ge-2/0/23), and connect ports 0, 1, and 2 from
module 1 to port 23 on Virtual Chassis VC1 (ge-0/0/23, ge-1/0/23, and ge-2/0/23).
To form the Director group, connect module 0, port 3 on Director device DG0 to module 0,
port 3 on Director device DG1. Similarly, connect module 1, port 3 on Director device DG0
to module 1, port 3 on Director device DG1.
Table 85 on page 334 shows the port mappings
for the Director group in this example.
333 Copyright © 2015, Juniper Networks, Inc.
Chapter 16: Initial Setup