Juniper QFX3000-G QFabric, Руководство по развертыванию, Страница: 311 / 652

Figure 77: QFX3000-G QFabric System Control Plane—Virtual Chassis
Port Ranges
Node devices
Ports 0-31
Interconnect devices
Ports 38-39
Director group
Ports 40-41
Inter-VC LAG
Ports xe-x/1/0 and xe-x/1/2
g041122
CAUTION:
The control plane network within a QFabric system should be considered
a critical component of the system that should not be shared with other
•
network traffic. In order to scale efficiently, the control plane network must
be reserved for the QFabric system and its components. As a result, the
ports of the QFabric system control plane must never be used for any
purpose other than to transport QFabric system control plane traffic, and
we neither recommend nor support the connection of other devices to the
QFabric system control plane network.
•
Do not install Junos Space and AI-Scripts (AIS) on the control plane network
Virtual Chassis in a QFX3000-G QFabric system.
NOTE: Not all port numbers are represented in Table 77 on page 285 , and ports
32 through 37 and ports 42 through 47 are reserved for future uses.
Table 77 on page 285 shows the specific mappings of QFabric system control plane network
ports from the Virtual Chassis to the QFabric system components.
Table 77: QFX3000-G QFabric System Virtual Chassis Control Plane Port Assignments
QFabric System
Component Member Port
Number
Member 3 Member 2 Member 1 Member 0
Node devices ge- X /0/0 Node96
ge-3/0/0
Node64
ge-2/0/0
Node32
ge-1/0/0
Node0
ge-0/0/0
285 Copyright © 2015, Juniper Networks, Inc.
Chapter 16: Initial Setup