Juniper QFX3000-G QFabric, Руководство по развертыванию, Страница: 305 / 652

To convert your device from standalone mode to Node device mode, follow these steps:
1.
Connect to your standalone device through the console port and log in as the root
user.
2.
Upgrade the software on your standalone device to a QFabric system Node and
Interconnect device software package that matches the QFabric system complete
software package used by your QFabric system. For example, if the complete software
package for your QFabric system is named
jinstall-qfabric-11.3X30.6.rpm
, you need to
install the
jinstall-qfx-11.3X30.6-domestic-signed.tgz
package on your standalone
device. Matching the two software packages ensures a smooth and successful addition
of the device to the QFabric system inventory.
root@switch# request system software add software-package-name reboot
3.
Back up your device configuration to an external location.
root@switch# save configuration-name external-path
4.
Check the current device mode by issuing the
show chassis device-mode
command.
root@switch>
show chassis device-mode
Current device-mode : Standalone
Future device-mode after reboot : Standalone
5.
Issue the request chassis device-mode command and select the desired device mode.
root@switch> request chassis device-mode node-device
Device mode set to 'node-device' mode.
Please reboot the system to complete the process.
6.
Verify the future device mode by issuing the
show chassis device-mode
command.
root@switch> show chassis device-mode
Current device-mode : Standalone
Future device-mode after reboot : Node-device
7.
Reboot the device.
root@switch>
request system reboot
Reboot the system ? [yes,no] (no) yes
Shutdown NOW!
[pid 34992]
root@switch>
*** FINAL System shutdown message from root@switch ***
System going down IMMEDIATELY
8.
Verify that the new device mode has been enabled by issuing the show chassis
device-mode
command.
root@switch> show chassis device-mode
Current device-mode : Node-device
Future device-mode after reboot : Node-device
9.
To enable a converted device to participate in the QFabric system, locate the applicable
network cables for your device and connect the device ports to the control plane and
data plane.
10.
(Optional) If you change the device back from Node device mode to standalone mode,
restore the saved backup configuration from your external location.
279 Copyright © 2015, Juniper Networks, Inc.
Chapter 16: Initial Setup