Juniper QFX3000-G QFabric, Руководство по развертыванию, Страница: 267 / 652

•
Connecting a QFX3500 Node Device to a Copper-Based QFX3000-G QFabric System
Control Plane Network on page 241
•
Connecting a QFX3500 Node Device to a QFX3008-I Interconnect Device on page 271
Connecting a QFX3500 Node Device to a Copper-Based QFX3000-G QFabric System
Control Plane Network
Supported Platforms
QFX3000-G
A QFX3000-G QFabric system control plane and management network is formed by
connecting the QFX series devices in your network to two Virtual Chassis composed of
EX4200 switches. If you are creating a copper-based control plane network, you use four
EX4200-48T Ethernet switches in each Virtual Chassis. QFX3500 Node devices have
an RJ-45 or SFP management board. Use the RJ-45 management ports (labeled
C0
and
C1
) to connect the QFX3500 Node device to each Virtual Chassis (see
Figure 67 on page 241 ).
Figure 67: QFX3500 Node Device Control Plane Connections
VC0
VC1
ge-0/0/0 ge-0/0/0
C1 C0
g041121
Use the following QFX3500 Node devices and EX4200 switches for a copper-based
QFX3000-M QFabric system control plane network:
• QFX3500 Node devices with an RJ-45 management board installed. The RJ-45
management board provides two RJ-45 1-Gbps management ports labeled
C0 and
C1 .
• EX4200-48T switches with an SFP+ uplink module installed.
Before you begin to connect a QFX3500 Node device to the QFX3000-G QFabric system
control plane network:
241 Copyright © 2015, Juniper Networks, Inc.
Chapter 13: Cabling a Copper-Based Control Plane for the QFX3000-G QFabric System