Juniper QFX3000-G QFabric, Руководство по развертыванию, Страница: 193 / 652

To remove the adjustable center-mounting brackets:
1.
Loosen the three screws at the top and bottom of each bracket.
2.
Remove the center-mounting brackets.
TIP: Save the center-mounting brackets and screws in case you need to
move the device to a two-post rack at a later time.
Related
Documentation
Site Preparation Checklist for a QFX3008-I Interconnect Device
•
Installing QFX3008-I Interconnect Device Mounting Hardware on Two-Post Racks
Supported Platforms QFX3000-G
Before you install the QFX3008-I Interconnect device in a two-post rack, you must first
install mounting hardware on the rack (see
Figure 25 on page 168 ). If spacer bars were
included in your shipment, they are not needed for this mounting option; however, you
can leave them attached to the front-mounting brackets.
NOTE: In a rack, the device uses 21 U. You can mount two QFX3008-I
Interconnect devices on a 42 U rack provided that the racks meet the strength
requirements to support the combined weight of the devices. If you are
mounting two QFX3008-I Interconnect devices on a rack, mount the first
device on the bottom of the rack.
167 Copyright © 2015, Juniper Networks, Inc.
Chapter 10: Installing a QFX3008-I Interconnect Device