Juniper QFX3000-G QFabric, Руководство по развертыванию, Страница: 301 / 652

CHAPTER 16
Initial Setup
• QFabric System Initial and Default Configuration Information on page 275
• Converting the Device Mode for a QFabric System Component on page 277
•
Example: Configuring the Virtual Chassis for the QFX3000-G QFabric System Control
Plane on page 283
• Example: Configuring a Fiber-Based Control Plane for the QFX3000-G QFabric
System on page 327
•
Importing a QFX3000-G QFabric System Control Plane Virtual Chassis Configuration
with a USB Flash Drive on page 359
• Generating the MAC Address Range for a QFabric System on page 361
• Performing the QFabric System Initial Setup on a QFX3100 Director Group on page 362
QFabric System Initial and Default Configuration Information
Supported Platforms
QFabric System
Once you install the hardware for the QFabric system, you can configure the Junos
operating system (Junos OS) to begin using the system. This topic discusses which setup
activities you need to perform and which activities are handled automatically by the
QFabric system.
The fabric manager Routing Engine in the Director group automatically handles some of
the initial setup activities, including:
• Assignment of IP addresses and unique identifiers to each QFabric system component
by way of the management control plane
•
Inclusion of all QFabric system devices within the default partition
•
Establishment of interdevice communication and connectivity through the use of a
fabric provisioning protocol and a fabric management protocol
The initial configuration tasks you need to perform to bring up the QFabric system and
make it operational include:
275 Copyright © 2015, Juniper Networks, Inc.