Juniper QFX3000-G QFabric, Руководство по развертыванию, Страница: 281 / 652

To connect a QFX3100 Director device to a network for out-of-band management:
1.
Connect one end of the Ethernet cable to the management port (labeled
MGMT
on
the Director device front panel).
2.
Connect the other end of the Ethernet cable to your management device or
management network.
3.
Repeat these steps for the second Director device.
Related
Documentation
Management Port Connector Pinouts for the QFX Series
•
•
Cable Specifications for Console and Management Connections for the QFX Series
•
Connecting QFX3100 Director Devices to a Copper-Based QFX3000-G QFabric System
Control Plane Network on page 231
•
Connecting QFX3100 Director Devices to a Copper-Based QFX3000-M QFabric System
Control Plane Network
•
Connecting QFX3100 Director Devices to a Fiber-Based QFX3000-M QFabric System
Control Plane Network
•
Connecting a QFX Series Device to a Management Console on page 151
Connecting a QFX3008-I Interconnect Device to a Fiber-Based QFX3000-G QFabric
System Control Plane Network
Supported Platforms QFX3000-G
A QFX3000-G QFabric system control plane and management network is formed by
connecting the QFX Series devices in your network to two Virtual Chassis composed of
EX4200 switches. If you are creating a fiber-based control plane network, you use eight
EX4200-24F Ethernet switches in each Virtual Chassis. QFX3008-I Interconnect Devices
have four small form factor pluggable plus (SFP+) management ports on each Control
Board (
CB0 and CB1 ). Use the SFP+ management ports to connect the QFX3008-I
Interconnect Devices to each Virtual Chassis (see Figure 74 on page 256 ).
255 Copyright © 2015, Juniper Networks, Inc.
Chapter 14: Cabling a Fiber-Based Control Plane for the QFX3000-G QFabric System