Juniper QFX3000-G QFabric, Руководство по развертыванию, Страница: 291 / 652

Figure 76: QFX3500 Node Device Fiber-Based Control Plane Connections
for QFX3000-M QFabric System
VC0
VC1
ge-0/0/0 ge-0/0/0
C1 C0
Use the following QFX3500 Node devices and EX4200 switches for a fiber-based
QFX3000-G QFabric system control plane network:
• QFX3500 Node devices with an SFP management board installed. The SFP
management board provides two small form-factor pluggable (SFP) 1-Gbps
management ports labeled
C0
and
C1
.
•
EX4200-24F switches with an SFP+ uplink module installed.
Before you begin to connect a QFX3500 Node device to the fiber-based QFX3000-M
QFabric system control plane network:
•
Install your QFabric system hardware (Director group, Interconnect devices, and Node
devices). For more information, see
“Installing and Connecting a QFX3100 Director
Device” on page 143 , “Installing and Connecting a QFX3008-I Interconnect Device” on
page 155 , “Installing and Connecting a QFX3600 or QFX3600-I Device” on page 193 , and
“Installing and Connecting a QFX3500 Device” on page 211 .
• Install your Virtual Chassis hardware (EX4200 switches). For more information, see
Installing and Connecting an EX4200 Switch .
•
Create two Virtual Chassis switches of eight members each. See Configuring an EX4200,
EX4500, or EX4550 Virtual Chassis (CLI Procedure) .
• Interconnect the two Virtual Chassis switches using the 10-Gigabit Ethernet SFP+
uplink ports. See
“Interconnecting Two Virtual Chassis for Copper-Based QFX3000-G
QFabric System Control Plane Redundancy” on page 225 .
265 Copyright © 2015, Juniper Networks, Inc.
Chapter 14: Cabling a Fiber-Based Control Plane for the QFX3000-G QFabric System