Intermec Trakker Antares 2460, Руководство пользователя

Страница: 178 / 291

TRAKKER Antares 246X Stationary Terminal User’s Manual Nugg
C d 39
8-30
Configuration Commands Via Serial Port (continued)
Notes: For COM1 only, you can use either command syntax listed next:
Syntax: YT1.data
Or: ITdata
where data is a value from 0 to 2. For COM2, you must use the YT configuration
command.
Controller IP Address
Purpose: Defines the IP address assigned to the DCS 300 server in your Ethernet network. An IP
address is a network level address you assign to each device in a TCP/IP network. The
controller IP address you set on the 2461 terminal must match the address that is set on
the DCS 300.
If you plan to enable DHCP (Dynamic Host Configuration Protocol), you can set the
controller IP address to any valid IP address. The T2461 will locate and reset the IP
address after you enable DHCP. For help, see “Dynamic Host Configuration Protocol
(DHCP)” later in this chapter.
Syntax: NCn.n.n.n
where each n address segment is a number from 0 to 255. The controller IP address
field consists of four separate numbers, each separated by a period.
Note: The Ethernet network cannot be activated if the first address segment in the IP
address is set to 0, 127, or a number greater than 223.
Default: 0.0.0.0
Scan: To set the default controller IP address, scan this bar code:
Default Controller IP Address
*$+NC0.0.0.0*
*$+NC0.0.0.0*
Or: To set the controller IP address:
1. Scan this bar code:
Enter Accumulate Mode / Set Controller IP Address
*+/$+NC*
*+/$+NC*