Intermec Trakker Antares 2460, Руководство пользователя

Страница: 110 / 291

TRAKKER Antares 246X Stationary Terminal User’s Manual Nugget
C d 39
6-4
Problems While Operating the Terminal
If you are operating the 246X terminal and have trouble, check these possible problems
and solutions.
Problem Solution
You press
W to turn on the 246X terminal
and nothing happens.
Make sure that you have plugged the power cable into the terminal and
the outlet. For help, see Chapter 2, “Installing the Terminal.” Replace the
power cable if damaged.
You scan a reader command, such as
Change Configuration, and nothing
happens. The reader commands are disabled. Scan the Enable Override command
shown here to temporarily enable all of the reader commands. For help,
see “Command Processing” in Chapter 8. When you are finished,
remember to disable the override so that your data is not interpreted as a
command.
Enable Override
*$+DC3*
*$+DC3*
You scan a valid bar code label to enter
data for your application. The data
decoded by the input device does not
match the data encoded in the bar code
label. The terminal may have decoded the bar code label in a symbology other
than the label’s actual symbology. Try scanning the bar code label again.
Make sure you scan the entire label.
To operate the terminal quickly and efficiently, you should enable only
the bar code symbologies that you are going to scan. If you enable
multiple symbologies, the terminal may on rare occasions decode a bar
code according to the wrong symbology and produce incorrect results.
You want to set the terminal back to the
default configuration to start over
configuring the terminal. Scan this bar code label:
Default Configuration
*.+*
*.+*
Note: After you load the default configuration, you may need to set the
network communications parameters on a 2461 to communicate with
other devices in the Ethernet network.