Intermec Trakker Antares 2460, Руководство пользователя

Страница: 209 / 291

Nugg
C d 39
Configuration Command Reference
8-61
8
3. Scan the parity setting:
No Parity Even Parity
*0* *1*
*0* *1*
Odd Parity
*2*
*2*
4. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
5. Repeat Steps 1 through 4 to set the parity for another serial port.
Notes: For COM1 only, you can use either command syntax listed next:
Syntax: YB1.data
Or: IBdata
where data is a value from 0 to 2 for the parity. For COM2, you must use the YB
configuration command.
Plessey
Purpose: Enables or disables decoding of Plessey symbology. Plessey code is pulse-width
modulated like most other bar codes. It includes a start character, data characters, an
eight-bit cyclic check digit, a termination bar, and usually a reverse start character. The
code is continuous and not self-checking. You need to configure two parameters for
Plessey code: Start Code and Check Digit.
Syntax: CIdata
Acceptable values for data are:
00 Disabled
10 Plessey with reverse start code
30 Transmit check digit
31 Discard check digit
Default: Disabled