Intermec Trakker Antares 2460, Руководство пользователя

Страница: 42 / 291

TRAKKER Antares 246X Stationary Terminal User’s Manual nugget
39
2-14
Charging the Backup Battery
The backup battery backs up all memory and the real-time clock in case of a power
failure. The backup battery is shipped inside the terminal, but may not be fully charged.
You need to fully charge the backup battery after you install the terminal.
The terminal continuously monitors the backup battery voltage level and charges the
backup battery whenever the voltage level gets low. You can operate the terminal while
the backup battery is charging.
To charge the backup battery
1. Make sure the power supply is connected to the terminal and a powered electrical
outlet.
2. Let the power supply charge the backup battery for 24 hours to fully charge the
backup battery.
Note: For more information about the backup battery, see “Learning About the Power
Supply and Backup Battery” in Chapter 1.
Configuring the Terminal to Communicate in Your Network
You need to configure the 246X terminal to communicate with serial or Ethernet
devices in your network. The parameters you configure depend on the type of network
or devices to which you want to connect the terminal.
Here are the parameters you need to set:
•
Time and Date
•
Serial port (COM1, COM2)
•
Ethernet (2461 only)
The next sections list the parameters you need to configure and explain how to use bar
code labels to configure the terminal.
Setting the Time and Date
You need to set the time and date on the terminal. You use bar code labels to set the
time and date.
To set the time and date
1. Scan this bar code:
Enter Accumulate Mode / Set Time and Date
*+/$+DB*
*+/$+DB*