Intermec Trakker Antares 2460, Руководство пользователя

Страница: 136 / 291

TRAKKER Antares 246X Stationary Terminal User’s Manual nugget
39
7-16
Receive File Through the Serial Port (continued)
From Network:
.%X n,drive:filename
Receives a file using
XMODEM
protocol
.%K
n,drive:filename Receives a file using
XMODEM-1K
protocol
.%Y n,drive:filename
Receives a file using
YMODEM
protocol
.%Y
n,drive: Receives a batch of files using
YMODEM
where:
.%X is the command to receive a file using
XMODEM
protocol.
.%K is the command to receive a file using
XMODEM-1K
protocol.
.%Y is the command to receive a file using
YMODEM
protocol.
n indicates the terminal’s serial port: 1 or 2.
drive: indicates the drive on the terminal where you want to receive and
store the file. You must include the colon (:) after the drive letter.
filename is the file you want to receive and save on the terminal.
Keypad: Not supported
Note: To scan these bar code labels, you must configure the terminal to use Code 39 in
Full ASCII mode. For help, see “Code 39” in Chapter 8.
Scan: 1. Scan this bar code label:
Enter Accumulate Mode / Receive File
*/K/O./E*
*+/.%*
2. Scan the bar code label for the communications protocol you want to use.
XMODEM XMODEM-1K YMODEM
*X* *K* *Y*
*X* *K* *Y*
3. Scan the bar code label for the terminal COM port you are using to receive the file.
The label also includes the required comma.
COM1 COM2 (2460 only)
*1/L* *2/L*
*1,* *2,*
4. Scan the bar code label(s) for the file you want to receive. You can scan labels from
the “Full ASCII Bar Code Chart” in Appendix B. The label must use this format:
drive:filename