Intermec Trakker Antares 2460, Руководство пользователя

Страница: 111 / 291

Nugget
C d 39
Troubleshooting
6-5
6
Problems While Operating the Terminal (continued)
Problem Solution
The terminal appears to be locked up and
you cannot enter data. Try these possible solutions:
•
(2461 only) Wait at least 10 seconds and try again. If the 2461 is still
connecting to the DCS 300 or host, the 2461 ignores any input from
the keyboard or input device. Make sure the Network Connect status
light remains on before continuing.
•
Scan any bar code label to see if the terminal responds.
•
Press
W to turn off the terminal. If it turns off, press W to turn on the
terminal. You can continue working.
•
If the terminal will not turn off, reboot the terminal. Scan this bar
code:
Boot Terminal
*-.1*
*-.1*
The system boots, clears RAM memory, and starts your application.
•
If the terminal will not boot or reset, contact your local Intermec
service representative for help.
The terminal is booting and you see a
message that POST failed. Report the error message to your supervisor. Press or scan Esc to exit the
error message. Scan this bar code:
Boot Terminal
*-.1*
*-.1*
Your application appears on the screen. If the terminal still will not boot,
contact your local Intermec service representative for help.
The Power status light blinks. The backup battery charge is low. Make sure that the power supply is
connected to the terminal and a powered electrical outlet. Let the power
supply charge the backup battery. The backup battery will be fully
charged in approximately 24 hours.
If the backup battery will not charge, you may need to replace it. For help,
contact your local Intermec service representative.