Intermec Trakker Antares 2460, Руководство пользователя

Страница: 191 / 291

Nugg
C d 39
Configuration Command Reference
8-43
8
Note: ACK is encoded as $F in a Code 39 bar code label.
Notes: For COM1 only, you can use either command syntax listed next:
Syntax: YJ1.data
Or: PGdata
where data is disabled or enabled (set to ACK). For COM2, you must use the YJ
configuration command.
Host IP Address
Purpose: Defines the IP address assigned to the host computer in your Ethernet network. An IP
address is a unique network level address you assign to each device in a TCP/IP direct
connect network. The host IP address you set on the 2461 must match the address that
is set on the host.
Syntax: NCn.n.n.n
where each n address segment is a number from 0 to 255. The host IP address field
consists of four separate numbers, each separated by a period.
Note: The Ethernet network cannot be activated if the first address segment in the IP
address is set to 0, 127, or a number greater than 223.
Default: 0.0.0.0
Scan: To set the default host IP address, scan this bar code:
Default Host IP Address
*$+NC0.0.0.0*
*$+NC0.0.0.0*
Or: To set the host IP address:
1. Scan this bar code:
Enter Accumulate Mode / Set Host IP Address
*+/$+NC*
*+/$+NC*