Intermec Trakker Antares 2460, Руководство пользователя

Страница: 186 / 291

TRAKKER Antares 246X Stationary Terminal User’s Manual Nugg
C d 39
8-38
End of Message (continued)
Or: To set EOM to one or two ASCII characters for one serial port:
Note: To scan these bar code labels, you must configure the terminal to use Code 39 in
Full ASCII mode. For help, see “Code 39” earlier in this chapter.
1. Scan this bar code:
Enter Accumulate Mode / Set EOM
*+/$+YZ*
*+/$+YZ*
2. Scan one of these bar codes to set the COM port:
COM1 COM2
*1.* *2.*
*1.* *2.*
3. Scan one or two bar codes for data from the “Full ASCII Bar Code Chart” in
Appendix B.
4. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
5. Repeat Steps 1 through 4 to set the EOM for another serial port.
Notes: For COM1 only, you can use either command syntax listed next:
Syntax: YZ1.data
Or: PFdata
where data is one or two ASCII characters. For COM2, you must use the YZ
configuration command.