Intermec Trakker Antares 2460, Руководство пользователя

Страница: 44 / 291

TRAKKER Antares 246X Stationary Terminal User’s Manual nugget
39
2-16
Configuring the Serial Port Parameters
You must first select the communications protocol for each COM port. Depending on
the protocol, you need to set some or all of these serial port parameters to have the
terminal communicate with a host computer or serial device in a wired network:
Serial Port Parameter Default Value
Baud rate 19200
Commands via serial port Enabled without TMF
Data bits 7
EOM (End of Message) \x03 (hexadecimal ASCII value for ETX)
Flow control None
Handshake Disabled
LRC Disabled
Parity Even
Poll (Polling) Disabled
Protocol Configurable
SOM (Start of Message) \x02 (hexadecimal ASCII value for STX)
Stop bits 1
Timeout delay 10 seconds
The values you set for the terminal’s serial port must match the values set for the host’s
(or other device’s) serial port. In a CrossBar network, you also need to configure your
9154 or 9161 controller to add the new multi-drop 2460 device. For help, see your
controller user’s manual.
You set the serial port parameters by scanning bar codes. For help, see Chapter 8,
“Configuration Command Reference.”