Intermec Trakker Antares 2460, Руководство пользователя

Страница: 130 / 291

TRAKKER Antares 246X Stationary Terminal User’s Manual nugget
39
7-10
Save Configuration in Flash Memory
Purpose: Saves the current runtime terminal configuration in flash memory. If you configure the
terminal by scanning bar code labels or sending commands from a network device, your
configuration changes are only saved in RAM. You can use this reader command to
save the changes to flash memory so that they are set the next time you boot or reset the
terminal.
From Network:
.+1
Scan: Save Configuration in Flash Memory
*.+1*
*.+1*
Scanner Trigger On and Off
The Scanner Trigger On and Off commands are the same as pulling and releasing the
scanner trigger. This command is valid on a 246X terminal only when you have an
Intermec 1545 laser scanner attached to the scanner connector.
After a Scanner Trigger On command, the scanner operates differently depending on
the Scanner mode and scanner trigger configuration settings:
•
If you configure the terminal to use One-Shot Scanner mode and level triggering,
the scanner automatically turns off after a good read of a bar code label, or after the
scanner timeout period elapses.
•
If you configure the terminal to use Automatic Scanner mode and level triggering,
the scanner remains on after a good read of a bar code label. You can use the
Scanner Trigger Off command to turn off the scanner, or set the Scanner Timeout
command to automatically turn off the scanner after it stays on for the period of
time set.
For help on configuring the Scanner Mode or Scanner Trigger commands, see Chapter
8, “Configuration Command Reference.”
Note: Intermec does not recommend that you use a Scanner Trigger On or Off
command with the Scanner Trigger command set to edge triggering.
Purpose: The Scanner Trigger On command is the same as pulling the trigger on the 1545 laser
scanner.
From Network:
/.
Scan: Not supported