Intermec Trakker Antares 2460, Руководство пользователя

Страница: 55 / 291

nugget
39
Configuring the Terminal
3-9
3
Saving Configuration Changes in Flash Memory
The 246X terminals use two copies of the configuration:
Runtime or RAM configuration
This configuration is the current or active set of
parameters and options enabled on the terminal. The configuration is stored in RAM
and will be lost if you boot or reset the terminal.
Boot or flash configuration
This configuration is the set of parameters and options
last saved in flash memory. The configuration is stored in flash memory and will be
saved and used if you boot or reset the terminal.
Here are the three ways that you can configure the terminal and how the configuration
is updated:
Configure the Terminal
Runtime or RAM
Configuration Updated? Boot or Flash
Configuration Updated?
Scanning bar code labels Yes No
From a host application through
the serial port Yes No
2461 terminal from the network
(DCS 300 or host) Yes No
If you configure the terminal by scanning bar code labels, through the serial port or
from the network, you may want to save the changes in flash memory by scanning or
sending the Save Configuration in Flash Memory reader command.
To save configuration changes using the reader command
•
Scan this bar code label:
Save Configuration in Flash Memory
*.+1*
*.+1*
Or, send the command
.+1
as the last command from the DCS 300 or host application.
For help, see Chapter 4, “Operating the Terminal in a Network.”