Intermec Trakker Antares 2460, Руководство пользователя

Страница: 128 / 291

TRAKKER Antares 246X Stationary Terminal User’s Manual nugget
39
7-8
Change Configuration
Purpose: This command must precede any configuration command. If you enter a valid string,
the terminal configuration is modified and the terminal sounds a high beep.
From Network:
$+ command[command]...[command n]
where command is a configuration command with the value you want to set.
Example: Change Configuration / Turn Off Beep Volume
*$+BV0*
*$+BV0*
The Change Configuration command is followed by the configuration command to turn
off the beep volume (BV0).
Default Configuration
Purpose: Sets the terminal to its default configuration, resets the firmware, boots the terminal,
and runs your application. The default configuration for the terminal is listed in
Appendix A. For help, see “Restoring the Terminal’s Default Configuration” in
Chapter 3.
When you use the Default Configuration command, the default configuration is saved
in RAM and flash memory. The runtime and boot configuration are changed to the
default configuration.
Note: In the default configuration, the Network parameters are set to the default
values. The 2461 terminal will no longer have a valid IP address and cannot
communicate with other devices. You need to configure the 2461 terminal again. For
help, see Chapter 4, “Operating the Terminal in a Network.”
From Network:
.+0
Scan: Default Configuration
*.+0*
*.+0*