Intermec Trakker Antares 2460, Руководство пользователя

Страница: 185 / 291

Nugg
C d 39
Configuration Command Reference
8-37
8
End of Message (EOM)
Purpose: Attaches an EOM to the end of a data block to indicate the end of data transmission to
and from a terminal. When EOM is disabled, the terminal communicates in Character
mode. When EOM is enabled, the terminal communicates in Frame mode.
You must configure a value for EOM before you can set these other serial
communications commands:
•
Configuration Commands Via Serial Port
•
Handshake
•
LRC
•
Start of Message (SOM)
EOM cannot equal the same value that is set for SOM. You cannot set EOM to any of
these values:
•
AFF (ACK)
•
REQ (ENQ)
•
DLE
•
SEL
•
NEG (NAK)
•
XOFF
•
Poll
•
XON
•
RES (EOT)
Syntax: YZn.data
where n is:
1 COM1 port
2 COM2 port
Acceptable values for data are one or two ASCII characters.
Default: \x03 (hexadecimal value for ETX)
Scan: To disable EOM for each serial port, scan one of these bar codes:
Disable EOM for COM1
*$+YZ1.*
*$+YZ1.*
Disable EOM for COM2
*$+YZ2.*
*$+YZ2.*