Honda NSS250A Reflex 2001-2007, Руководство пользователя

Страница: 539 / 718

BATTERY/CHARGING SYSTEM
19-7
VOLTAGE INSPECTION
Remove the battery cover (page 19-6).
Measure the battery voltage using a digital
multimeter.
If the battery voltage is below 12.4 V, charge the bat-
tery (page 19-7).
BATTERY TESTING
Refer to the instructions that are appropriate to the
battery testing equipment available to you.
CHARGING SYSTEM INSPECTION
CURRENT LEAKAGE INSPECTION
Remove the battery band (page 19-6).
Turn the ignition switch OFF and disconnect the bat-
tery negative (–) cable from the battery.
Connect the ammeter (+) probe to the battery nega-
tive (–) cable and the ammeter (–) probe to the bat-
tery negative (–) terminal.
With the ignition switch turned OFF, check for cur-
rent leakage.
• When measuring current using a tester, set it to a
high range, and then bring the range down to an
appropriate level. Current flow higher than the
range selected may blow out the fuse in the
tester.
• While measuring current, do not turn the ignition
switch ON. A sudden surge of current may blow
out the fuse in the tester.
If current leakage exceeds the specified value, a
shorted circuit is the probable cause.
Locate the short by disconnecting connections one
by one and measuring the current.
VOLTAGE:
Fully charged: 13.0 – 13.2 V
Under charged: Below 12.4 V
TOOL:
Battery tester
BM-210 or BAT-
TERY MATE or
equivalent
SPECIFIED CURRENT LEAKAGE: 1.5 mA max.
(–) PROBE
NEGATIVE (–) CABLE (+) PROBE
maxiscooter-club.ru