Honda NSS250A Reflex 2001-2007, Руководство пользователя

Страница: 230 / 718

FUEL SYSTEM (PGM-FI)
6-76
FUEL FLOW INSPECTION
Disconnect the quick connect fitting from the fuel
pump unit (page 6-71).
Remove the fuse/relay box cover (page 3-17).
Temporarily install the connect the fuel pump unit
5P (Natural) connector and negative (–) cable.
Turn the ignition switch OFF.
Remove the fuel pump relay and jump the Brown
and Black/yellow wire terminals of the wire side
using a jumper wire.
Wipe spilled
gasoline out of the
container.
Place the end of the fuel feed hose into an approved
gasoline container.
Connect the hose attachment, 6 mm/9 mm to the
fuel pump unit.
Turn the ignition switch ON and engine stop switch
" " for 10 seconds.
Measure the amount of fuel flow.
If the fuel flow is less than specified, inspect the fol-
lowing:
– Clogged fuel filter (Faulty fuel pump unit)
– Clogged fuel cap breather hole
– Fuel pump unit (page 6-76).
Connect the quick connect fitting to the fuel pump
unit (page 6-73).
FUEL PUMP UNIT
INSPECTION
Turn the ignition switch ON and engine stop switch
" " and confirm that the fuel pump operates for a
few seconds.
If the fuel pump does not operate, inspect as fol-
lows:
Remove the luggage lower box (page 3-16).
Remove the clamp from the fuel pump set plate.
Disconnect the fuel pump unit 5P (Natural) connec-
tor.
FUEL PUMP RELAY JUMPER WIRE
TOOL:
Hose attachment, 6 mm/9 mm
07ZAJ-S5A0130
Amount of fuel flow:
77 cm
3
(2.6 US oz, 2.7 Imp oz) minimum
/10 seconds at 12 V
JUMPER WIRE HOSE 6 mm/9 mm
FUEL PUMP UNIT 5P CONNECTOR
CLAMP
maxiscooter-club.ru