Honda NSS250A Reflex 2001-2007, Руководство пользователя

Страница: 680 / 718

Honda S Matic System (NSS250A)
24-36
9. Movable Drive Face Position Sensor Resistance
Inspection 2
Measure the resistance at the movable drive face
position sensor 3P connector terminals of the
sensor side by turning the sensor shaft groove
of the sensor with your fingers.
• Do not damage the movable drive face posi-
tion sensor.
Is there resistance within 0 – 6.0 k
Ω
(20
°
C/68
°
F)?
YES – GO TO STEP 10.
NO – Faulty movable drive face position sen-
sor.
10. Movable Drive Face Position Sensor Power
Input Voltage Line Inspection
Turn the ignition switch ON and engine stop
switch " ".
Measure the voltage at the position sensor 3P
connector of the wire side.
Is the voltage within 4.75 – 5.25 V?
YES – GO TO STEP 11.
NO – • Open or short circuit in Yellow/black
wire
• Open circuit in Green/orange wire
• Replace the PCM with a known good
one and recheck.
11. Movable Drive Face Position Sensor Signal Line
Continuity Inspection
Turn the ignition switch OFF.
Connect the test harness 21P to the PCM 21P
(Black) connector (page 24-12).
Check the continuity between the test harness
terminal and movable drive face position sensor
3P connector of the wire side.
Is there continuity?
YES – GO TO STEP 12.
NO – Open circuit in Yellow/blue wire
CONNECTION: A – B
STANDARD:
0 – 6.0 k
Ω
(20
°
C/68
°
F)
3P CONNECTOR
(Sensor side/male terminals)
POSITION SENSOR
CONNECTION:
Yellow/black (+) – Green/orange (–)
STANDARD: 4.75 – 5.25 V
3P CONNECTOR
(Wire side/female terminals)
Green/orange Yellow/black
CONNECTION: B1 – Yellow/blue
TEST HARNESS 21P
3P CONNECTOR
(Wire side/female terminals)
Yellow/blue (B1)
maxiscooter-club.ru