Hakko Electronics Monitouch V Series, Справочное руководство

Страница: 538 / 746

Chapter 22 Data Logging
22-9
22
W
hen
St
or
ing
to
a CF
Ca
rd
:
Buffering Area Setting and Memory Card Setting
When using a CF card, be sure to select [Store Target: CF Card] in the [Buffering
Area Setting] dialog. The editor recognizes [Output File No.] that you specify,
identifies [No.] of the appropriate [Memory Card Setting], and automatically sets
[Type: Buffering File].
Cache Setting
When writing data into a CF card, you should collect data into a “cache” in the V
series. This is because a CF card has a limitation on writing times. When the
cache is full or only when needed, you can write all data in the cache into a CF
card at once. To do this, select [CF Card Setting] from the [System Setting]
menu.
Setting and Importing Procedures on the V Series
To start data logging, perform the following procedures on the V series:
♦
Note
•
Unless you reset a CF card, the data stored on a CF card is saved.
(Except when you format a CF card.)
•
When you remove a CF card from the V7 series, sampling is temporarily
stopped and data is not imported. If sampling data is displayed on the
screen, the data is lost. When you reset a CF card, the history of data
imported in the past is displayed and sampling begins again.
For more information on cache, refer to “Chapter 23 CF Card (V7 Only).”
Connect the V series to the PLC.
[ Format Buffering Area Automatically] [ Format Buffering Area Automatically]
Sampling format is the same.
Start sampling.
Sampling format is different.
Perform auto-formatting. Perform formatting.
Immediately after running, sampling is possible and data logging begins.
Perform the [SMPL_CSV] macro command.
* When importing data to a CF card as a CSV file