Hakko Electronics Monitouch V Series, Справочное руководство

Страница: 302 / 746

Chapter 10 Sampling
10-7
10
S
a
mp
lin
g M
ode
T
y
p
e
s
•
It is possible to display errors with distinction between the “first cause” and
“others.” When monitoring bit activation (ON/OFF), you will notice that the
setting of a bit (first cause) causes secondary and tertiary bits to be set as
well. When this occurs, it is possible to distinguish which bit was set first and
which bits were set after, and thus it is possible to specify which bit is the first
cause bit.
Example: When a belt conveyor error occurs:
By marking the first cause with an asterisk (
∗
) when the error messages are
displayed, you can distinguish the first cause error from the other errors.
ON
OFF
OFF
OFF
Normal operation bit
Error No. 1 bit (first cause)
Error No. 2 bit
Error No. 3 bit
It is possible to distinguish between error No. 1 and other errors.
(* To be reset when an error occurs)
ON
OFF
OFF
OFF
S
A1 A2 A3
2. 1st sensor error 3. 2nd sensor error
(Advance direction)
1. 2nd roller error (first cause) = conveyor stop
Errors 2 and 3 are triggered by error 1.
In this case, error 1 is called “first cause.”
To show the above in a circuit diagram ...
S: Normal operation bit (
∗
To be reset when an error occurs)
A1: 2nd roller error bit (first cause)
A2: 1st sensor error bit
A3: 2nd sensor error bit
02/11/15 16:15:43
02/11/15 16:15:51
02/11/15 16:15:52
2nd roller error
1st sensor error
2nd sensor error
First cause mark